Functionalized pyrolytic highly oriented graphite polymer film for surface‐assisted laser desorption/ionization mass spectrometry in environmental analysis

The pyrolytic highly oriented graphite polymer film (PGS) was first employed to analyze low‐mass analytes in environmental analysis by surface‐assisted laser desorption/ionization mass spectrometry (SALDI‐MS). PGS is a synthetic uniform and highly oriented graphite polymer film with high thermal anisotropic conductivity. We have found that negative ion mode SALDI‐MS using oxidized PGS (PGS‐SALDI‐MS) can be used to detect [M–H]^? ions from perfluorooctanoic acid (PFOA) and other perfluoroalkylcarboxylic acids when the PGS surface is modified with the cationic polymer polyethyleneimine (PEI). The signal intensity of PFOA when employing the PEI modification showed a ten‐fold increase over that obtained from desorption/ionization on porous silicon (DIOS). PFOA was quantified using PGS‐SALDI‐MS and the calibration curve showed a wide linear dynamic range of response (20–1000 ppb). The combination of atmospheric pressure ionization and PGS (AP‐PGS‐SALDI) showed greater signal intensity than vacuum PGS‐SALDI for deprotonated PFOA. Several other environmentally important chemicals, including perfluoroalkylsulfonic acid, pentachlorophenol, bisphenol A, 4‐hydroxy‐2‐chlorobiphenyl, and benzo[a]pyrene, were also successfully used to evaluate PGS‐SALDI‐MS. In addition, we found that nonafluoro‐1‐butanesulfonic acid was able to produce protonated peptides in positive ion PGS‐SALDI‐MS, but that perfluoropentanoic acid and trifluoroacetic acid were not. It is suggested that perfluoroalkylsulfonic acids are better protonating agents than perfluoroalkylcarboxylic acids in SALDI‐MS. Copyright © 2009 John Wiley & Sons, Ltd.     

Surface structures and osteoblast response of hydrothermally produced CaTiO3 thin film on Ti-13Nb-13Zr alloy

This study investigated the surface characteristics and in vitro biocompatibility of a titanium (Ti) oxide layer incorporating calcium ions (Ca) obtained by hydrothermal treatment with or without post heat-treatment in the Ti-13Nb-13Zr alloy. The surface characteristics were evaluated by scanning electron microscopy, thin-film X-ray diffractometry, X-ray photoelectron spectroscopy, atomic force microscopy and contact angle measurements. In vitro biocompatibility of the Ca-containing surfaces was assessed in comparison with untreated surfaces using a pre-osteoblast cell line. Hydrothermal treatment produced a crystalline CaTiO₃ layer. Post heat-treatment at 400 °C for 2 h in air significantly decreased water contact angles in the CaTiO₃ layer (p < 0.001). The Ca-incorporated alloy surfaces displayed markedly increased cell viability and ALP activity compared with untreated surfaces (p < 0.001), and also an upregulated expression of various integrin genes (α1, α2, α5, αv, β1 and β3) at an early incubation time-point. Post heat-treatment further increased attachment and ALP activity in cells grown on Ca-incorporated Ti-13Nb-13Zr alloy surfaces. The results indicate that the Ca-incorporated oxide layer produced by hydrothermal treatment and a simple post heat-treatment may be effective in improving bone healing in Ti-13Nb-13Zr alloy implants by enhancing the viability and differentiation of osteoblastic cells.     

Equiaffine immersions of general codimension and its transversal volume element map

With an equiaffine immersion of codimension 1 into the affine space with the natural equiaffine structure, the conormal map is associated. In this paper, for an equiaffine immersion of general codimension into the space, we shall define the map corresponding to the conormal map, which is called the transversal volume element map. And we shall investigate if, an equiaffine immersion of general codimension into the space is determined by its affine fundamental form and its transversal volume element map.     

Automated phosphoproteome analysis for cultured cancer cells by two-dimensional nanoLC-MS using a calcined titania/C18 biphasic column.

We have developed an on-line automated system for phosphoproteome analysis using titania-based phosphopeptide enrichment followed by nanoLC-MS/MS. Titania beads were prepared by calcination of commercial chromatographic titania beads at 800 degrees C to convert the crystalline structure. The obtained rutile-form titania exhibited higher selectivity in phosphopeptide enrichment than commercial titania, even in the absence of a competitive chelating reagent for non-phosphopeptides. For phosphoproteome analysis of human cervical cancer HeLa cells, tryptic digests of the cell extracts were directly injected into this on-line system, and 696 non-redundant phosphopeptides with 671 unambiguously determined phosphorylation sites, derived from 512 phosphoproteins, were successfully identified. This is the first successful application of an on-line automated phosphoproteome analysis system to complex biological samples.     

Catalytic asymmetric synthesis of descurainin via 1,3-dipolar cycloaddition of a carbonyl ylide using Rh2(R-TCPTTL)4

A catalytic asymmetric synthesis of descurainin has been achieved by incorporating an enantioselective 1,3-dipolar cycloaddition, a stereoselective alkene hydrogenation, an oxidation with Fremy’s salt and a regioselective demethylation with NbCl₅ as the key step. The 1,3-dipolar cycloaddition of a carbonyl ylide derived from tert-butyl 2-diazo-5-formyl-3-oxopetanoate with 4-hydroxy-3-methoxyphenylacetylene in the presence of dirhodium(II) tetrakis[N-tetrachlorophthaloyl-(R)-tert-leucinate], Rh₂(R-TCPTTL)₄, provided an 8-oxabicyclo[3.2.1]octane skeleton in 95% ee.     

Observation of transverse polarization asymmetries of charged pion pairs in e+e- annihilation near √s = 10.58 GeV

The interference fragmentation function translates the fragmentation of a quark with a transverse projection of the spin into an azimuthal asymmetry of two final-state hadrons. In e(+)e(-) annihilation the product of two interference fragmentation functions is measured. We report nonzero asymmetries for pairs of charge-ordered π(+)π(-) pairs, which indicate a significant interference fragmentation function in this channel. The results are obtained from a 672 fb(-1) data sample that contains 711 × 10(6) π(+)π(-) pairs and was collected at and near the Υ(4S) resonance, with the Belle detector at the KEKB asymmetric-energy e(+)e(-) collider.     

Synthesis and magnetic properties of ALnO2 (A=Cu or Ag; Ln=rare earths) with the delafossite structure

Synthesis, structures, and magnetic properties of ternary rare earth oxides ALnO₂ (A=Cu or Ag; Ln=rare earths) have been investigated. CuLnO₂ (Ln=La, Pr, Nd, Sm, Eu) were synthesized by the direct solid state reaction of Cu₂O and Ln₂O₃, and AgLnO₂ (Ln=Tm, Yb, Lu) were obtained by the cation-exchange reaction of NaLnO₂ and AgNO₃ in a KNO₃ flux. These compounds crystallized in the delafossite-type structure with the rhombohedral 3R type (space group: R-3m). Magnetic susceptibility measurements showed that these compounds are paramagnetic down to 1.8 K. Specific heat measurements down to 0.4 K indicated that CuNdO₂ ordered antiferromagnetically at 0.8 K.     

Measurement of the tau lepton mass and an upper limit on the mass difference between tau+ and tau-

The mass of the tau lepton has been measured in the decay mode tau-->3pinutau using a pseudomass technique. The result obtained from 414 fb-1 of data collected with the Belle detector is Mtau=[1776.61+/-0.13(stat)+/-0.35(sys)] MeV/c2. The upper limit on the relative mass difference between positive and negative tau leptons is |Mtau+-Mtau-|/Mtau<2.8 x 10-4 at 90% confidence level.